This article will cover the Standard Procedures for rescue of surface supplied divers. This article also includes CPR and identification of a drowning diver. Before performing a rescue dive, it is a good idea to have a complete certification. Then, you will know how to save the lives of other divers in an emergency. It discusses how to locate the victim, perform CPR on unconscious divers, and other important topics.
Standard procedure for salvaging a surface-supplied diver
Rescuers must immediately respond to any difficulty a surface-supplied diver may be experiencing and transport him or her safely to safety. This is usually a dive bell or an area in which the diver cannot drown. First aid can also be administered. There may be times when the bell isn't reachable. In these cases, rescue divers have to modify their response.
The first step in rescue is to secure the diver's umbilicals. The diver should exit the bell by the side of the bell where the umbilical enters. The surface tender should then follow in the footsteps of the diver's umbilical as it leaves the bell. Depending upon the bell type, the diver could also be supplied by the individual umbilicals. The diver's umbilicals will need to be secured to avoid snagging.
The diving supervisor and the diver's tender should provide instructions to rescuers. While a diver being rescued may have other duties, a standby dive should be available to render assistance to the diver in an emergency. While performing this procedure, it is important to keep in constant physical and/or audio contact with the diver.
Identifying a lost diver
Identifying a lost diver can be a challenging task, but fortunately, there are many ways to find someone missing in the water. First, contact the local authorities. In this instance, the diver had been reported missing on June 17, in Mukilteo. Fire and police departments responded to the call. The Coast Guard, sheriff's diving team and police also searched the area. However, Korompis' and his partner were not found.
An alternative method to find a lost diver is using a MOB unit. This device uses an underwater radio signals to transmit a distress signal. The device works only if there are nearby vessels that receive the signal. This device is highly recommended, but it is not always practical. Many boats do not have AIS technology and will not be able to locate a lost diver. SAR teams will still be able to assist the diver if there is an AIS signal on the vessel.
CPR is performed on an unconscious diver
CPR can be used to revive a diver who isn't breathing. To open the airway, slide your hand beneath the diver's arm. Or reach up to the diver and hold their breathing equipment. Now, hold the diver's breathing equipment and pinch his or her nose. Roll him/her toward you. If breathing is not returning, give two rescue breaths and repeat the procedure two to three times.
It is important to avoid trying to retrieve the bell of a diver during CPR. This could cause blood pooling. You should continue to rescue breathe until the diver can regain consciousness. It may be necessary to transfer the diver onto a decompression chamber. Performing CPR on an unresponsive diver may be a complicated task, but it is necessary.
If you can see the diver's pulse, you can use positive buoyancy to bring him to the surface. This will let you assess the condition of your diver and determine whether he requires rescue breathing. You can alternate rescue breaths with 30 chest compressions if the diver isn't breathing. Alternate your breathing pattern for no more than 30 seconds.